! Attention: your HS printer may either have a A13 or a A20 olimex board. At this point you can lift the motherboard and start working on the olimex board Now you need to disconnect the USB cable connecting the olimex board to the motherboard, the Z induction sensor wire, the stepper motor connectors and the cable powering the motherboard so you can safely lift the motherboard and expose the olimex Ħ. Now that the electronic assembly is exposed the next step is to gain access to the olimex board in order to check the FTDI adaptor which helps enable the connection between the PC and printer įor this you will have to lift the motherboard which is bolted above the olimex using four bolts, one on each corner.ĥ. Now remove the side panels of the printer and the top interior cover plate to expose the electronic assembly of the HS printer Ĥ. If this does not work next turn off the printer and remove the power cable from the socket ģ.
LEAPFROG CONNECT NOT CONNECTED DRIVERS
If you are using windows 8 or 10 please refer to the link below and download the drivers for you operating system:Ģ.
LEAPFROG CONNECT NOT CONNECTED UPDATE
If your Creatr HS printer is not connecting to the PC even after the software and firmware update you will have to do the following steps:ġ. Hello and thank you for choosing the Creatr HS for your printing needs. "My Leapfrog Creatr HS Printer is not Connecting to the PC Even After the Software and Firmware Update. Modified on: Wed, 11 Mar, 2020 at 9:00 AM Solution home Creatr HS (XL) 3D Printer Repair Instructions Creatr HS Printer not connecting to PC (after updates)
0 kommentar(er)
